Quick Connect Sodastream Cylinder Filling Adapter

$119.00 NZD

Note: Only for Gaia - Duo - Terra - Art Clip on quick connect Sodastream or oh bubbles Cylinders.

This easy to use quick connect Soda stream Cylinder Filling Adapter will enable you to fill your own CO2 from your larger bulk cylinder into smaller SodaStream cylinders.

Co2 Cylinder:
Buy a Full Size 3kg (1M3) cylinder here from us or Eziswap - Swap when empty at any EziSwap center around NZ

An easy and inexpensive way to fill your own Sodastream Cylinders at home at a fraction of the cost of getting the refills from your local store.

When using, be sure to following these important points:
1. That the seals goes in the correct location. So when the SodaStream Filler arrives, please make sure to use the correct seal in the correct side.

Direct to machine hoses:
Direct Co2 cylinder Hose to Sodastream Machine are also available from us here:
QC full Hose + Fitting here
Cylinder Filling Station here:
QC cylinder filling station here:

Details & Instructions:
With a 3.5KG co2 cylinder could fill a sodstream bottle about 8-9 times.
Refills of the 3.5kg cylinder cylinders cost about $80

A typical Soda Stream cylinder can only carbonate up to 60L and will cost about $30 per re-fill at retailers. So given these figures the larger cylinder and this fill station will pay itself off once you fill the 3.5kg gas cylinder once. It's a no brainer!

Setup Tips:

When using a co2 bottle you will need invert the co2 cylinder (make a stand for is to be safe) You need to invert as most co2 cylinders don't have a dip tube and you want the liquid co2 to transfer.

Use a fire extinguisher with type 30 valve. These have dip tubes already installed so you can keep it upright. They are much easier to use and cheaper than a co2 cylinder.

Soda stream cylinder have a safety valve that protects then from being filled. You need to start the fill very slowly to ensure the valve does not close. Once the gas is flowing you can speed up the fill. If gas is not flowing you will need to detach the sodastream cylinder to reset the valve and start again.

Usage:

READ ALL STEPS AND FOLLOW PRECISELY FOR SAFETY

1) Attach fill station to Co2 donor cylinder nice and tight. The Gasket on the filling station will seal on the co2 cylinder. (spares included if you ever happen to loose it)

2) Attach SS cylinder into filling device - Push fit into Yellow Gasket area.

3) Screw in the side silver pin (this is also the gas release)

4) Open the co2 donor cylinder or fire extinguisher very slowly and keep open

5) You will hear the gas start to transfer.

6) Once the gas stops flowing (you will hear by the sound) you can close the co2 cylinder

7) Then unscrew the silver knob to release residual gas

8) Then remove the sodastream cylinder.

9) then take the fill station off the co2 bottle (optional)

Ask a Question

QUESTIONS & ANSWERS

Ask a Question

Hey just wanted to check. In order to fill a terra cylinder at home I would only require this adapter and the 1M3 cylinder? No hose required or anything like that? Thanks!

Correct - that is all you will need.
Note - The cylinder needs to be put upside down (make some kind of cradle) to trasnfer the liquid co2. Or get a cylinder with a dip tube to the bottom.